10 Piece Disc Brake Caliper Tool Set

Pusher Screw Handle (R)
3/8" Square Dr. Adapter (2 Pins Ø = 6mm)
55mm(2-3/16") Adapter
54mm(2-1/8") Adapter (1 Pin Ø = 5.5mm)
63mm(2-1/2") Adapter (1 Pin Ø = 5.5mm)
51mm(2") Adapter (1 Long & 2 Short Pins Ø = 6mm)
32mm(1-1/4") Adapter (2 Short Pins Ø = 5mm)
42mm(1-5/8") Adapter (2 Long Pins Ø = 6mm)
42mm(1-5/8") Adapter (2 Short Pins Ø = 6mm)
47mm(1-7/8") Adapter (1 Pin Ø = 5.5mm)
Blow Case

Jack up the car and support on axle stands, Then remove the relevant road wheel.
Remove the caliper from its carrier and take out the brake pads.
Fit the main body of the wind back tool into the caliper, turn the main thrust bolt clockwise to compensate for the distance between the position and caliper body.
Select the correct adapter and fit it to the end of the main thrust bolt, continue rotating into the mating recesses in the piston.
Turn the thrust bolt to wild the caliper piston back into its housing.
Fit the new brake pads and bolt the caliper back into the carrier.

Technical data

Accessories	piros műanyag tároló táska
Weight	2,1 kg
Quantity	10 db

Add to favourites

Compare