7pc double flaring tool set

Double flaring tool set, 7pc
Special design for double or single flare in copper, aluminum, soft steel brake line and brass tubing up to 45°.
Includes five adapters: 3/16", 1/4", 5/16", 3/8", 1/2" (4.8mm through 12.7mm).
Chrome swivel is made of alloy steel to reduce friction.
Forged yoke is made of heat treated steel.

Instructions:
This tool is designed to double flare thin wall steel tubing, aluminum and 0.40 wall soft copper
1. End of tubing must be cut square.
2. Deburr inside of tubing and chamfer outside.
3. Place tubing in correct hole with nut closest to tubing. Make certain tubing will not slip.
4. Tighten flaring bar firmly starting with nut closest to tubing. Make certain tubing will not slip.
5. Fit adaptors stem into tubing.
6. Place anvil over adaptor and turn down until adaptor contacts flaring bar.
7. Remove adaptor. End of tubing should be bell shaped.
8. Place anvil over bar and turn anvil down until tubing folds in on itself.
9. Remove tool and tubing should look like.

Technical data

Material	ötvözött és hőkezelt acél.
Accessories	szürke tároló doboz (190x140x30mm)
Weight	0,92 kg
Quantity	7 db

Add to favourites

Compare